If it does not, order the replacement interface board (see right). Order the LCU3-K Cable if your rig already has this board. TS-50, TS-711, TS-811, TS-940, TS-140, TS-680 need an interface board installed inside the radio. This is in addition to the LCU3-K Level Converter Cable. *TS-440 & R-5000 need the CHSET-1 Chipset installed in the radio. TS-440*, TS-450, TS-690, TS-790, TS-850, TS-950, R-5000*, and other rigs that list a Kenwood IF-232C as an option.īuy the W1GEE LCU3-K Level Converter Cable terminated with a male 6-din plug. The Ten-Tec Orion & Orion 2 need a straight-thru RS-232 extension cable, male on one end, female on the other. You may use our LCU-3 interface if you wish to take advantage of the CI-V technology which allows you to run several rigs on the same serial port. If your computer does not have a free RS-232 port, order our USB-RS232 adapter. The IC-7800 has a built-in interface and needs only an inexpensive straight-thru cable with a female connector at one end, and a male at the other. Use a commonīe sure to Install the drivers as instructed in the manual.Īn LCU3-I level converter may be used also. If you have a UX-14 installed in your radio, all you need is the LCU3-I-USB cable (with a USB jack). Look for a 1/8' phone jack labeled REMOTE or something like that on the back of your rig. Requires a UX-14 interface or compatible replacement.

You may also purchase a separate USB-RS232 adapter.

Or buy the W1GEE LCU3-I Cable terminated with a 1/8” phone plug on one end and a 9-pin female DB9 serial connector on the other. Also TenTec Argonaut II, Delta II.īuy the W1GEE LCU3-I-USB cable (USB cable). ICOM AND TENTEC ICOM AND TENTEC ICOM AND TENTEC Buy the serial extension cable (Straight thru, 9-pin male one end, 9-pin female on the other). This chart will help you determine what to order. Interface your rig's VFO to your computer for remote control and automatic logging of frequency, band, and mode.

Ic-756 pro ii vs ts-590